Coleman 5151C Dokumentacja Pobierz pdf (Strona 11)

ROOF JACKS

Only use the appropriate roof jack.

See TABLE 4 & TABLE 5 for correct application.

Do not exceed the maximum height as determined from

TABLE 4 & TABLE 5. Installer should allow an addition-

al 1--

” travel before the flue pipe assembly is fully ex-

tended against the built--in stop. This provides an addi -

tional safeguard against the flue assembly being pulled

from the roof jack during transportation or other stress

conditions.

Improper installation may d amage the equipment, can

create a hazard, and will void the warranty.

Carefully follow all instructions and warnings to avoid

Fire, Explosion, Or Asphyxiation.

Locating and Cuttin g Roof Jack Openin g

To facilitate the proper installation of the roof jack, it is very

important that the roof jack opening in the ceiling and roof be

on the same vertical center line as the furnace flue collar.

SeeFigure7.

The dimensions shown in Figure 7 may be used if the fur-

nace is flush with the walls or adjusted to allow for any spac-

ing away from either wall.

Mark this location on ceiling and scribe a circle with a 5” ra-

dius (10” diameter) around this mark. Cut opening for roof

jack through ceiling and roof. (If furnace was installed dur-

ing construction, cover furnace and flue opening to

prevent debris from entering flue and combustion air

when hole is cut for roof jack.)

9--3/4”

12--1/4”

Mark Center

Figure 7 — Location of Roof Jack Opening

TEMPLATE FRONT

These dimensions may be

used if furnace fits snug

against wall.

Installing Roof Jack in Roof

(Se e Figure 8 & Figure 9 for Dime nsiona l re quire ment s.)

Insert roof jack into opening in the roof.

The roof jack should be secured to the furnace before

roof flange (flashing) is secured to the roof. This will in-

sure a better alignment of the flue pipe and furnace flue col-

lar. Caulk completely around the underside of the roof jack

flashing to provide a rain tight seal, before securing roof jack

flashing to roof. After roof jack flashing has been secured to

the roof, caulk carefully all around swivel joint with sealant

supplied by furnace manufacturer.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

Coleman 5151C Dokumentacja Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Coleman 5151C